Cleaning - Waring VCM1000SK Instruction Manual

you will hear a buzzing noise. After a few seconds you will hear a click, and the
buzzing noise will stop. This is the safety-reset switch shutting off the motor.
Possible causes of a motor shutdown
• Food becomes jammed between the processing plate and the bowl or cover.
• An unusually heavy load is being processed for a lengthy period of time.
To restart the motor, follow these steps:
• Turn the machine OFF by pressing the PULSE / OFF (
• Unplug the machine.
• Clear the batch processing bowl (or continuous feed chute) of the food that
caused the jamming condition. It may be that you only need to remove
some of the food.
• Wait for at least 1 minute to allow the motor to cool.
• Plug the unit into the appropriate electrical outlet.
• Press the red Safety Reset Switch located on the back of the Safety
Interlock Tower.
• Press down the ON ( ) paddle or the PULSE (
machine. We suggest pulsing to start the processing, as this will put less
strain on the motor.
• If the machine does not start, wait for another minute and repeat this
procedure.
Clean the food processor and accessories prior to initial use and after
each use. Do not use harsh abrasive-type cleaners on any part of the food
processor.
Wash the motor shaft with a small brush.
Wash, rinse, sanitize and dry the bowl, continuous feed chute, covers,
small food pusher, large food pusher, accessory discs, S-blades and ejector/
slinger disc prior to initial use, and after use, unless they will be used again
immediately. These items are all dishwasher-safe, and may be cleaned and
rinsed in the dishwasher instead of manually in the sink.
Wash and rinse all of the above items after each use.
Some of the discs and blades have aluminum components. Whether cleaning
them manually or in a dishwasher, be sure to use a detergent that is safe for
use with soft metals. Other types of cleaning detergents can cause corrosion
of soft metals.
A stiff bristle brush will help to knock food particles out of the crevices of the
discs and blades before washing. Handle very carefully, since the blades
are sharp.
Please note that all accessory discs and blades may be disassembled with
a screwdriver for thorough cleaning. This includes the cutting blades on the
center hub of the S-blade. Handle the sharp S-blade with care.

CLEANING

14
) paddle.
) paddle to restart the