Wiring - Siemens Simatic S7-1500 Manual

Wiring

This section contains the block diagram of the module and outlines various connection
options.
You can find information on wiring the front connector, creating a cable shield, etc. in the
Wiring section of the system manual S7-1500/ET 200MP
(https://support.industry.siemens.com/cs/ww/en/view/59191792).
Note
You may use and combine the different wiring options for all channels.
Do not insert the potential jumpers supplied with the front connector.
Abbreviations used
QV
n
QI
n
S +/S
n
L+
M
M
ANA
Pin assignment for the power supply element
The power supply element is plugged onto the front connector for powering the analog
module. Wire the supply voltage to terminals 41 (L+) and 44 (M). Use terminals 42 (L+) and
43 (M) to loop the potential to the next module.
Figure 3-1
Analog output module AQ 4xU/I ST (6ES7532-5HD00-0AB0)
Manual, 09/2016, A5E03484696-AD
Voltage output channel
Current output channel
- Sense line channel
n
Connection for supply voltage
Ground connection
Reference potential of the analog circuit
Power supply element wiring
3
13