Table of Contents
Advertisement
_ _ !i___ '_¸ ' ! :i ¸ 'i_i ii ii_: _ _
OVEN _R
:
: :
Proportionalvalves have an adjustingscrew located
Do not place excessiveweight on an open oven dooror
insidethe valve stem. Valvesthat do not have this screw
stand on an open oven door as, in some cases, it could
can not be adjusted,
cause the range to tip over, break the door or cause
serious injury to the user.
The LO setting should produce a stable flame when
turning the knob from HI to LO. On conventional surface
When opening the oven door, allow steam and hot air to
burners, the flame should be 1/8-inchtall or lower and
escape before reaching into the oven to check, add or
must be stable on all ports on LO setting. For sealed
remove food.
surface burners, the flame should extendto the outer
Do not attemptto open or close the door until the door i.,
edge of the lip on the burner cap on the LO setting,
completely seated on the hinge arms. Never turn on the
oven unless the door is properly in place. When baking,
To adjust: Operate burner on HI for about 5 minutesto
be certain the door is completely closed. Baking results
preheat the burner cap. Turn the knob back to LO; remove
will be affected if the door is not securely closed.
knob, and insert a small screwdriverinto the center of the
valve stem. Adjust the flame size by turning the
CAUTION: Hinge arms are spring mounted and will
adjustment screwin either direction,
slam shut against the range if accidently hit. Never
place hand or fingers betweenthe hinges and the
front oven frame. You could be injured if hinge snap_
back.
To remove lift-off door: When the door is cool, open th
doorto the "stop"position (openedabout6 inches)and
graspthe door at each side.Do notusethe doorhandle
to liftthe door.Liftup evenlyuntilthe doorclearsthe
hingearms.
The flame must be of sufficientsize to be stable on all
I__
burner ports.If the flame adjustment is needed,adjust
ONLYon the LO setting. Never adjust flame size on a
higher setting.
O_
_INDOW, if_i
....
To protect the oven door window:
To replacedoor: Graspthe doorat each side,alignthe
1. Do not use abrasive cleaningagents such as steel
slots in the doorwith the hinge arms and slide the door
wool scouring pads or powdered cleansersas they
down onto the hinge arms until it is completely seated or
may scratchthe glass,
the hinges.
2. Do not hit the glass with pots, pans, furniture, toys, or
other objects.
O_N LIGHT, if
_Ui_ ed
Beforereplacingthe lightbulb,DISCONNECTPOWER
3. Do notclosethe ovendooruntilthe oven racks are in
TO THE RANGE.Be sure the bulbis cool.Do nottouch
place,
hot bulbwith a dampclothas the bulbmay break.
Scratching,hitting,jarring or stressingthe glassmay
To turn on oven light: Push_
f_
weaken its structure causing an increasedrisk of
in the rocker switch located /
,"
breakage at a later date.
on the backguard or on the _
IIFi'LJ . ...
manifold panel.
To replace oven light: Be sure the bulb is cool. Use a
dry potholder,to prevent possible harm to hands,and
very carefully unscrew bulb.
Replace with a 40 watt appliance bulb and reconnect
powerto the range. Resetthe clock.
Advertisement
Table of Contents
