Pentax L Operating Manual page 158

156
Using in Wireless Mode
1 Place the AF360FGZ at the desired location.
2 Set the AF360FGZ power switch to [WIRELESS].
3 Set the AF360FGZ wireless mode to S (Slave).
4 Turn the camera mode dial and set the exposure mode to e, b, c or
a mode.
5 Set the AF360FGZ power switch on the camera to [WIRELESS].
6 Set the AF360FGZ wireless mode on the camera to a (Master) or A
(Control).
• Wireless mode is not available for the built-in flash.
• Set the AF360FGZ wireless slave mode to SLAVE1.
Wireless Flash Control (P-TTL Flash Mode)
5
The following information is exchanged between the two AF360FGZ
flash units before the flash is discharged when the AF360FGZ is used
for wireless flash.
Press the shutter release button fully.
1 The camera's flash discharges a pre-flash. (The camera's flash
mode is transmitted.)
2 The external flash unit discharges a pre-flash. (The subject's
lighting condition is checked.)
3 The camera's flash unit discharges a pre-flash. (The required
flash output is transmitted to the external flash.)
* The
flash duration in HSb (High-speed sync).
4 The external flash discharges the main flash.
Set the AF360FGZ wireless slave mode to SLAVE1.
camera's
flash will discharge another pre-flash to transmit the