Jeep WRANGLER 2017 Owner's Manual page 480

478 MULTIMEDIA
Conference Call
When two calls are in progress (one active and one on
hold):
1. Push and hold the Phone
double beep, indicating that the two calls have been
joined into one conference call.
Three-Way Calling
To initiate three-way calling, push the Voice Command
button while a call is in progress, and make a second
phone call, as described under "Making a Second Call
While Current Call is in Progress." After the second call
has established, push and hold the Phone
until you hear a double beep, indicating that the two
calls have been joined into one conference call.
Call Termination
To end a call in progress:
1. Momentarily push the Phone
• Only the active call(s) will be terminated and if there is
a call on hold, it will become the new active call. If the
active call is terminated by the phone far end, a call on
hold may not become active automatically. This is cell
phone-dependent.
button until you hear a
button
button.
2. To bring the call back from hold, push and hold the
Phone button until you hear a single beep.
Redial
To redial the last number called from your mobile phone
using Voice Command:
1. Push the Phone button to begin.
2. After the "Ready" prompt and the following beep, say
"Redial."
• The Uconnect Phone will call the last number that was
dialed from your mobile phone.
NOTE: This may not be the last number dialed from the
Uconnect Phone.
Call Continuation
Call continuation is the progression of a phone call on the
Uconnect Phone after the vehicle ignition has been
switched to OFF. Call continuation functionality available
on the vehicle can be any one of three types:
1. After the ignition is switched to OFF, a call can continue
on the Uconnect Phone either until the call ends, or until