Table of Contents
Advertisement
Setting the Shake Reduction Function
The [Shake Reduction] menu appears when the camera is turned on with the
Shake Reduction switch on and a type of lens that does not support automatic
acquisition of lens information such as focal length (p.47) is mounted.
Use the [Shake Reduction] menu to set the [Focal Length].
• [Focal Length] cannot be set manually on the [Shake Reduction] menu when
using a lens that supports automatic acquisition of lens information such as
focal length because [Focal Length] is set automatically.
• Set [FI with S lens used] on the [A Custom Setting] menu to [Available] to
enable the focus indicator when using a screw mount lens. If this is set to
[Unavailable], the camera assumes there is no lens attached, and the Shake
Reduction function cannot be used.
• When using a lens without the s position on the aperture or with the aperture
set to a position other than the s position, set [Using aperture ring] on the [A
Custom Setting] menu to [Permitted].
1
Use the four-way controller
(op) to set [Focal Length].
Select from the following 34 focal length
values. (The default setting is 35.)
8
10 12 15 18 20 24 28 30 35
40 43 50 55 65 70 77 85 100 120
135 150 180 200 250 300 350 400 450 500
550 600 700 800
• If the focal length for your lens is not listed above, select the value closest to
the actual focal length.
• When using a zoom lens, select the actual focal length at the zoom setting in
the same manner.
• Effect of Shake Reduction is influenced by the shooting distance as well as
focal length information. The Shake Reduction function may not perform as
expected when shooting at close ranges.
2
Press the 4 button.
The camera is ready to take a picture.
To change the [Focal Length] setting, use [Shake Reduction] on the [A Rec.
Mode] menu. (p.104)
Shake Reduction
Focal Length
120
100
135
Cancel
49
3
OK
OK
Advertisement
Table of Contents
