Advanced Usage
Setting the DIP Switches
On this printer, you can make various settings with DIP switches.
The DIP switches are already set for the current interfaces. Change the setting if necessary.
Functions of the DIP switches differ depending on the interface.
For models with the buzzer function, see also
Built-in Buzzer)" on page
Setting Procedure
Follow the steps below to change the DIP switch settings.
Before you remove the DIP switch cover, turn the printer off.
Otherwise, a short-circuit may cause the printer to malfunction.
CAUTION
• DIP switch settings are enabled only when the power is turned on or the printer is reset
• Do not change switches that are fixed to ON or OFF. Otherwise, the printer may not
1
Make sure the power supply for the printer is turned off.
2
Unscrew the screw to remove the DIP switch cover from the base of the
printer.
42.
via the interface. If the settings are changed after that, the functions will not change.
operate normally.
Chapter 4 Advanced Usage
"Setting the Built-in Buzzer (for Model with a
4
55