Xerox WorkCentre Pro 412 Service Manual page 84

Maintenance & Troubleshooting
Error Message
GROUP NOT
AVAILABLE
Error Message
LINE ERROR
LOAD DOCUMENT
MEMORY FULL
NO ANSWER
NO. NOT
ASSIGNED
NO PAPER
[ADD PAPER]
OVERHEAT
7-2
Description
You have tried to select a group
location where only a single
location number can be used,
such as when adding locations
for a multi-dial operation.
Description
Your unit cannot connect with the
remote machine, or has lost con-
tact because of a problem on the
phone line.
You have attempted to send a
FAX document with no document
loaded.
The memory has become full.
The remote machine did not
answer after all the re-dial
attempts.
The speed dial location you tried
to use has no number assigned
to it.
The paper has run out. The
printer system stops.
The printer has overheated.
August 2001
Solution
Try again, check location for
group.
Solution
Try again. If failure persists,
wait an hour or so for the line to
clear then try again.
Load a document and try
again.
Either delete unnecessary doc-
uments, or re-transmit after
more memory becomes avail-
able, or split the transmission
into more than one operation.
Try again.
Make sure the remote machine
is OK.
Dial the number manually with
the keypad, or assign the num-
ber to the speed dial and try
again.
Load new paper in the paper
tray.
The machine will automatically
return to the standby mode
when it cools down to normal
operating temperature. If fail-
ure persists, install a new ELA
HOU-FUSER, PL 1-14.
WorkCentre Pro 412
Launch Issue