Bosch PST 650 L Operating Instructions Manual page 13

OBJ_BUCH-2 609 000 687-001.book Page 2 Tuesday, February 1, 2005 3:50 PM
f) Keep cutting tools sharp and clean. Prop-
erly maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to
control.
g) Use the power tool, accessories and tool
bits etc., in accordance with these instruc-
tions and in the manner intended for the
particular type of power tool, taking into
account the working conditions and the
work to be performed. Use of the power tool
for operations different from those intended
could result in a hazardous situation.
5) Service
a) Have your power tool serviced by a quali-
fied repair person using only identical
replacement parts. This will ensure that the
safety of the power tool is maintained.
Machine-specific
Safety Notes
Do not point the laser beam at per-
sons or animals and do not look
into the laser beam yourself, not
even from a large distance.
This machine generates class 2 laser
irradiation
EN 60825-1:2001. It is possible to
unintentionally blind other persons.
B Shut the laser beam off for stationary opera-
tion of the machine. In stationary operation you
can easily be blinded by the laser beam.
B Do not use the laser viewing glasses as safety
goggles. The laser viewing glasses are used for
improved visualisation of the laser beam, but they
do not protect against laser irradiation.
B Do not use the laser viewing glasses as sun
glasses or in traffic. The laser viewing glasses do
not afford complete UV protection and reduce col-
our perception.
B Never make warning signs on the machine
unrecognisable.
B Never use the machine with a damaged cable.
Do not touch the damaged cable and pull the
mains plug when the cable is damaged while
working. Damaged cables increase the risk of an
electric shock.
2 609 000 687 • 1.2.05
B Connect machines that are used in the open
B Do not work materials containing asbestos.
B Use suitable detectors to determine if utility
B Secure the workpiece. A workpiece clamped
B Use only sharp, flawless saw blades. Bent or
B Apply the machine to the workpiece only
B Keep hands away from the sawing range. Do
B Pay attention that the base plate 6 rests
B When the cut is completed, switch off the
in accordance with
B Do not brake the saw blade to a stop by apply-
B Always wait until the machine has come to a
B Never allow children to operate the machine
English–2
via a residual current device (RCD).
Asbestos is considered carcinogenic.
lines are hidden in the work area or call the
local utility company for assistance. Contact
with electric lines can lead to fire and electric shock.
Damaging a gas line can lead to explosion. Pene-
trating a water line causes property damage or may
cause an electric shock.
with clamping devices or in a vice is held more
secure than by hand.
unsharp saw blades can break or cause kickback.
when switched on. Otherwise there is danger of
kickback when the cutting tool jams in the work-
piece.
not reach under the workpiece. Contact with
the saw blade can lead to injuries.
securely on the material while sawing. A
jammed saw blade can break or lead to kickback.
machine and then pull the saw blade out of
the cut only after it has come to a standstill. In
this manner you can avoid kickback and can place
down the machine securely.
ing side pressure after switching off. The saw
blade can be damaged, break or cause kickback.
complete stop before placing it down. The tool
insert can jam and lead to loss of control over the
power tool.
without supervising them. They could uninten-
tionally blind other persons.