Front Light Group; Headlight Adjustment - PIAGGIO xevo 250IE User Manual

Front light group (03_24, 03_25, 03_26, 03_27, 03_28)

To access the bulbs:
1. Remove the rear-view mirrors.
2. Loosen the five screws «A» and remove the headlight cover.
3. Take out the headlight assembly from its housing by removing the two screws
«B» and the screw «C» placed inside the front mudguard.
To reassemble, repeat the operation in the reverse order.
03_24
To replace the tail light bulbs «D», take out the rubber bulb holder and slide off the
bulb.
To replace the high beam «E» and low beam «F» bulbs, remove the rubber cap, take
out the bulb holder and slide off the light bulb.
WARNING
HIGH AND LOW BEAM LIGHT ARE OF THE HALOGEN TYPE: DO NOT TOUCH
WITH YOUR FINGERS TO AVOID DAMAGING THEIR FUNCTION.
03_25

Headlight adjustment (03_29, 03_30)

Proceed as follows:
1. Position the unloaded vehicle, in running order and with the tyres inflated to the
prescribed pressure, on a flat surface 10 m away from a half-lit white screen; ensure
that the longitudinal axis of the vehicle is perpendicular to the screen;
2. Turn on the headlight and check that the borderline of the projected light beam
should be lower than 9/10 of the distance from the ground to the centre of the vehicle's
headlight, and higher than 7/10;
03_26
3. If not, adjust the headlight by turning the central screw «A» placed under then
Piaggio emblem.
62