Spark Plug Dismantlement - PIAGGIO xevo 250IE User Manual

TYRES MUST BE REPLACED WHEN THE TREAD REACHES THE WEAR LIMITS
SET FORTH BY LAW.
Characteristic
Front tyre pressure (with passenger)
2.3 bar (-)
Rear tyre pressure (with passenger)
2.6 bar (-)

Spark plug dismantlement (03_07, 03_08)

Proceed as follows:
1. Remove the access cover over the spark plug on the right-hand side of the scooter
and reach into the spark plug with your hand;
2. Disconnect spark plug HV wire cap «A» ;
3. Unscrew the spark plug using the spark plug wrench supplied;
4. When refitting, place the spark plug into the hole at the required angle and tighten
by hand until it is finger tight;
03_07
5. Use the wrench only for final tightening of the spark plug;
6. Place hood "A" fully over the spark plug.
N.B.
THE USE OF SPARK PLUGS OTHER THAN THE INDICATED TYPE OR OF
SHIELDLESS SPARK PLUG CAPS CAN CAUSE ELECTRICAL SYSTEM FAIL-
URES.
03_08
48