Wolf E SERIES Installation Manual page 3

SPECIFICATIONS
Installation Requirements
The oven can be installed in a standard or flush inset
application. Location of the electrical supply within the oven
opening may require additional cabinet depth. Refer to the
chart below.
Finish the edges of the opening. They may be visible when
the door is open.
For flush inset installations, a minimum 6 mm reveal is
required on all sides. To ensure consistent 6 mm reveals,
each corner of the opening must be exactly 90°.
INSTALLATION REQUIREMENTS
BASE SUPPORT
Single Oven
Double Oven
CABINET DEPTH
Standard Installation 610 mm min
Flush Inset Installation 635 mm min
Flush Inset (contemporary model) 641 mm min
TRIM (STANDARD INSTALLATION)
Top Overlap
Bottom Overlap
Side Overlap
COMBINATION INSTALLATIONS
Wolf built-in ovens are designed and agency approved for
installation with Wolf cooktops, microwaves and warming
drawers only. The nominal width of the oven should match
the nominal width of the cooktop. A built-in oven cannot be
installed below a Wolf rangetop.
For typical combination installations, refer to the Wolf
Design Guide.
The single oven may be installed next to another E series
single oven. You must allow for a 38 mm space between
oven openings. A separate inner wall is required for each
oven between openings.
115 kg
181 kg
16 mm
3 mm
19 mm
Electrical
Installation must comply with all applicable electrical codes.
Locate the electrical supply flush with the back wall and
within the shaded area shown in the illustration for your
specific installation on the following pages. For ease of
installation, the electrical supply for the oven can be placed
in an adjacent cabinet within reach of the conduit. Use only
the conduit supplied with this appliance.
The wiring diagram covering the control circuit is provided
with the oven.
ELECTRICAL REQUIREMENTS
SINGLE OVEN SINGLE PHASE
Required Power Supply 220-240V AC 380-415V AC
50/60 Hz 50/60 Hz
Maximum Connected Load 4.4 kW
Total Amps 19
DOUBLE OVEN SINGLE PHASE
Required Power Supply 220-240V AC 380-415V AC
50/60 Hz 50/60 Hz
Maximum Connected Load 7.4 kW
Total Amps 32
RATING
PLATE
Rating plate location.
WARNING
The complete appliance must be properly grounded at
all times when electrical power is applied.
3PHASE
4.4 kW
19
3PHASE
5.1 kW
22
wolfappliance.com
|
3