Maintenance - Prem-I-Air EH1550 Manual

At any time it is possible to press the "–" button to return to the previous hour
period.
P
Then press to save the settings for the first day, and move on to the second
day of the week. The
Repeat until all seven days have been programmed.
When all seven days have been programmed, press
run the program that has been entered (
The progamming function can be locked to prevent tampering by pressing both
the + and – keys together and holding down for 3 seconds.
The function can be unlocked to allow programming by pressing both the + and –
keys together again and holding down for 3 seconds.
The display shows [ _ _ ] to indicate that the panel is locked.
Do not touch the case when the heater is in operation, because it will be hot.
Unplug the heater from the mains when not in use.
Before cleaning, turn the heater off, and disconnect from the mains supply. The
heater may then be cleaned using a damp cloth with a drop of washing-up liquid
to remove any dust or dirt from the case. Do no use stronger detergents or
solvents as these may damage the plastic.
If the mains lead is damaged, it must be replaced by the manufacturer or and
authorised service centre.
If the mains plug needs to be replaced, proceed as follows:
cable) and it fully tightened.
symbol will flash above the figure "2".
P

MAINTENANCE

Connect the brown wire to the terminal
•
labelled "L".
Connect the blue wire to the terminal
•
labelled "N".
Connect the green/yellow wire to the
•
terminal labelled with the earth symbol or
"E".
Make sure that the cord-grip is positioned
•
correctly (over the outer sheath of the
6
P
again and the heater will
shown in the display).