Before Use; Installation - Prem-I-Air EH1550 Manual

IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the user of the product
for future reference.

BEFORE USE

You must inspect the appliance including its cable and plug for any signs of
damage. If the product is damaged, DO NOT use it, and contact your supplier
immediately.

INSTALLATION

For free-standing use: Attach the two castor-wheel brackets to the underneath
of the heater using the eight M4x8 mm screws (four in each bracket). The longer
side of the bracket goes at the back of the heater. Attach two castor-wheels to
each bracket using the dome-nuts provided.
To wall-mount: Depress the two clips and remove the wall-mounting bracket
from the heater. Using the bracket as a template, and using a spirit level to
makes sure that the bracket is fitted level, drill four holes in the wall, the lower
holes should be be at least 160 mm above the floor. Insert a wall-plug into each
hole. Fix the bracket to the wall with the four screws supplied. Align the two
raised areas on the back of the heater with the lower part of the bracket, then
clip the heater into the bracket at the top (see photo).
If correctly installed the heater will be firmly fixed at both top and bottom.
PAT TESTING
2