Attachment According To Iec 60534-6 - Samson 3730-1 Mounting And Operating Instructions

Attachment to the control valve – Mounting parts and accessories
4.2 Attachment according to
IEC 60534-6
− Required mounting parts and accesso-
ries: Table 3
− Observe the travel table on page 15.
The positioner is attached to the control valve
using a NAMUR bracket (10).
1. Screw the two bolts (14) to the bracket
(9.1) of the stem connector (9), place the
follower plate (3) on top and use the
screws (14.1) for fastening.
2800 and 1400 cm² with 120 mm trav-
el:
− For a travel of 60 mm or smaller,
screw the longer follower plate (3.1)
directly to the stem connector (9).
− For a travel exceeding 60 mm, mount
the bracket (16) first and then the fol-
lower plate (3) to the bracket togeth-
er with the bolts (14) and screws
(14.1).
2. Mount NAMUR bracket (10) to the con-
trol valve as follows:
− For attachment to the NAMUR rib,
use an M8 screw (11) and toothed
lock washer directly in the yoke hole.
− For attachment to valves with rod-
type yokes, use two U-bolts (15)
around the yoke. Align the NAMUR
bracket (10) according to the em-
bossed scale so that the follower
plate (3) is shifted by half the angle
range to the NAMUR bracket (the
slot of the follower plate is centrally
aligned with the NAMUR bracket at
mid valve travel).
20
3. Mount connecting plate (6) or pressure
gauge bracket (7) with pressure gauges
on the positioner, making sure the two
seals (6.1) are seated properly.
4. Select required lever size (1) M, L or XL
and pin position according to the actua-
tor size and valve travel listed in the trav-
el table on page 15.
Should a pin position other than position 35
with the standard M lever be required, or an
L or XL lever size be required, proceed as
follows:
5. Screw the follower pin (2) in the assigned
lever hole (pin position as specified in the
travel table). Only use the longer follow-
er pin (2) included in the mounting kit.
6. Place the lever (1) on the shaft of the po-
sitioner and fasten it tight using the disk
spring (1.2) and nut (1.1).
Move lever once all the way as far as it
will go in both directions.
7. Place positioner on the NAMUR bracket
in such a manner that the follower pin (2)
rests in the slot of the follower plate (3,
3.1). Adjust the lever (1) correspondingly.
Screw the positioner to the NAMUR
bracket using both its mounting screws.
EB 8384-1 EN