Pptp Or L2Tp Wan Connection - D-Link DIR-620 Quick Installation Manual

DIR-620

PPTP or L2TP WAN Connection

1. Go to the Net / Connections page and select the WAN connection.
2. In the General settings section, select the IPoE value from the
Connection Type drop-down list.
3. In the Physical layer section, select the value corresponding to the
INTERNET port of the router (port 5) from the Physical interface
drop-down list.
4. If your ISP uses MAC address binding, enter the address registered by
your ISP upon concluding the agreement in the MAC field.
5. For Static IP connection: fill in the IP Address, Netmask, Gateway
IP Address, and Primary DNS server fields.
6. For Dynamic IP connection: select the Obtain an IP address
automatically and Obtain DNS server addresses automatically
checkboxes.
7. Click the Save button.
8. On the Net / Connection page, click the Add button.
9. In the General settings section, specify a name for your connection
(any name for easier identification) in the Name field and select a needed
value (PPTP or L2TP) from the Connection Type drop-down list.
10. In the Physical layer section, select the WAN value from the Physical
interface drop-down list.
11. Fill in other fields on the page in accordance with data provided by the
ISP.
12. Click the Save button.
13. On the Net / Connections page, select the choice of the Default
gateway radio button corresponding to the new PPTP or L2TP WAN
connection.
Quick Installation Guide
14