Assigning Input Sources - Crown 2/300 Operation Manual

Assigning Input Sources

Input sources can be assigned from the Input Source screen (see
preset (Preset 1) is configured with all analog inputs feeding their respective output
channels.
To assign input sources:
1� From the Home screen, press the MENU button.
2� Select the "Configure Amplifier" option from the menu using the ENCODER.
3� Select the "Input Source" option.
4� Use the ENCODER to select each input channel block and edit the input channel
source assignment.
TIP: When assigning a BLU link input channel, the "BLU" option must first be
selected from the list, then the ENCODER must be pressed. Turning the ENCODER
will then select the desired BLU link channel from the list.
5� When done, select "Done" at the bottom of the screen.
Available options:
• Analog 1
• Analog 2
• Analog 1+2 (mono summed)
• Analog 3*
• Analog 4*
• Analog 3+4* (mono summed)
• Any available BLU link channel**
• None
For information on assigning input sources in Audio Architect, see
*Channel 3 and 4 options available in 4-channel CDi DriveCore models only.
**BLU link options available in BLU link CDi DriveCore models only. BLU link channels 129-256 not available when operating a 96kHz BLU link bus.
Page 14
Configuring the Amp
). The default
Figure 14
"Assigning Input Sources in Audio Architect" on page 33
CDi DriveCore Series Operation Manual
Figure 14:
Input Source screen
.