Choosing Amplifier Input Wire And Connectors; Choosing Speaker Output Wire And Connectors; Choosing Control Input And Output Connectors; 选择功放输入连接线和端口 - Crown ct16s Operation Manual

2 Setup
(continued)
2 安装
（接上一页）
Figure 2.3 Amp Input and Speaker Output Wiring
图2.3 功放输入和扬声器输出连接
WARNING: Custom wiring should only be performed by qualified personnel. Never use
shield cable for output wiring. Do mind the cable polarity and prevent accidental reverse
connection.

2.4 Choosing Amplifier Input Wire and Connectors

Crown recommends using pre-built or professionally wired 14-20 AWG wire stripped about 7mm to 10mm.
PRIMARY INPUTS: Use 2-pin Euroblock connector cable ends to connect to the PRIMARY INPUTS connectors, see
Figure 2.3.
BACKUP INPUTS: Use 2-pin Euroblock connector cable ends to connect to the BACKUP INPUTS connectors, see Figure
2.3.

2.5 Choosing Speaker Output Wire and Connectors

Crown recommends using pre-built or professionally wired 14-20 AWG wire stripped about 7mm to 10mm. Use 2-pin
Euroblock connectors, see Figure 2.3.
2.6 Choosing Control Input and Output Wire and Connectors
Crown recommends using pre-built or professionally wired 16-24AWG wires stripped about 7mm to 10mm.
CONTROL INPUTS: Choose an available terminal and the grounding terminal on the 9-pin barrier type connector to
connect your external emergency device, see Figure 2.4.
CONTROL OUTPUTS: Choose an available pin and grounding terminal on the 6-pin barrier type connector to connect
page 10
PRIMARY
INPUTS
BACKUP
INPUTS
MAIN
OUTPUTS
CT16S 16-Channel Amplifier Switcher
Figure 2.4 Control Input Wiring
图2.4 控制输入连接
CONTROL INPUTS
警告：
只能由专业人员进行接线操作。连接输出线缆时，切勿使用屏蔽电缆。特别
留意连接线的极性并防止接反。
2.4 选择功放输入连接接口
Crown推荐您采用预装的或专业的14-20线规缆线，并预留7毫米到10毫米的裸线。
PRIMARY INPUT（主功放输入接口）：使用2针式Euroblock连接器标准线缆连接到主功放输入接
口。
BACKUP INPUTS（备用功放输入接口）： 使用2针式Euroblock连接器标准线缆连接到备用功放
输入接口。
2.5 选择扬声器输出连接接口
Crown推荐您采用预装的或专业的14-20线规缆线，并预留7毫米到10毫米的裸线。使用针式
Euroblock连接器进行连接。
2.6 选择控制输入和输出接口
Crown推荐您采用预装的或专业的16-24线规缆线，并预留7毫米到10毫米的裸线。
控制输入：选取9针式连接器上的一可用端口和接地端口，以连接您的外接紧急音源。如图2.4。
控制输出：选取6针式连接器上的一可用端口和接地端口，以连接您的外接控制设备。如图2.5。
CT16S
16通道主备功放切换器
Figure 2.5 Control Output Wiring
图2.5 控制输出连接
CONTROL OUTPUT S
Operation Manual
操作手册