Factory Reset - Crown 2/300 Operation Manual

Factory Reset

The Factory Reset allows a CDi DriveCore amplifier to be reverted back to its factory default state. When initiated, the Factory Reset will perform the
following tasks:
• Erase all user presets (this includes all user DSP and configuration settings)
• Reset all system settings
• Reset all BLU link settings (applicable to BLU link CDi DriveCore models only)
To perform the Factory Reset procedure:
Warning! All user presets will be permanently deleted and all settings reverted back to their factory default state. This process is irreversible. If you have
any user presets you wish to keep, they should be backed up using Audio Architect before performing the Factory Reset. See
for more information.
Preset Files" on page 43
1� Power off the amplifier by pressing and holding the Power button for 2 seconds.
2� Press and hold the CH1 and CH2 SELECT buttons while powering on the amp. Continue to hold these buttons until the LCD reads: "Press MENU to
restore Factory Settings or any other button to exit". Now release the SELECT buttons.
3� Press and release the MENU button to start the Factory Reset procedure (pressing any other button will abort the Factory Reset procedure and the
amp will boot up normally).
4� Once the Factory Reset procedure begins, the LCD will display the message: "Restoring factory defaults!" and when complete, the device will boot up
normally.
CDi DriveCore Series Operation Manual
Factory Reset
"Managing Device &
Page 65