Viewing Igmp Groups; Adjusting Timers; Adjusting Query And Response Timers - Dell Z9500 Configuration Manual

IGMP is enabled on interface
IGMP query interval is 60 seconds
IGMP querier timeout is 125 seconds
IGMP max query response time is 10 seconds
IGMP last member query response interval is 1000 ms
IGMP immediate-leave is disabled
IGMP activity: 0 joins, 0 leaves, 0 channel joins, 0 channel leaves
IGMP querying router is 1.1.1.1 (this system)
IGMP version is 3

Viewing IGMP Groups

To view both learned and statically configured IGMP groups, use the following command.
• View both learned and statically configured IGMP groups.
EXEC Privilege mode
show ip igmp groups
Example of the show ip igmp groups Command
Dell# show ip igmp groups
Total Number of Groups: 2
IGMP Connected Group Membership
Group Address Interface
225.1.1.1 TenGigabitEthernet 1/1
225.1.2.1 TenGigabitEthernet 1/1

Adjusting Timers

The following sections describe viewing and adjusting timers.
To view the current value of all IGMP timers, use the following command.
• View the current value of all IGMP timers.
EXEC Privilege mode
show ip igmp interface
For more information, refer to the example shown in

Adjusting Query and Response Timers

The querier periodically sends a general query to discover which multicast groups are active. A group must have at least one
host to be active.
When a host receives a query, it does not respond immediately, but rather starts a delay timer. The delay time is set to a
random value between 0 and the maximum response time. The host sends a response when the timer expires; in version 2, if
another host responds before the timer expires, the timer is nullified, and no response is sent.
The maximum response time is the amount of time that the querier waits for a response to a query before taking further action.
The querier advertises this value in the query (refer to the illustration in
latency but increases response burstiness because all host membership reports must be sent before the maximum response
time expires. Inversely, increasing this value decreases burstiness at the expense of leave latency.
When the querier receives a leave message from a host, it sends a group-specific query to the subnet. If no response is
received, it sends another. The amount of time that the querier waits to receive a response to the initial query before sending a
second one is the last member query interval (LMQI). The switch waits one LMQI after the second query before removing the
group from the state table.
• Adjust the period between queries.
INTERFACE mode
ip igmp query-interval
Mode Uptime Expires
IGMPV2 00:11:19 00:01:50
IGMPV2 00:10:19 00:01:50
Viewing IGMP Enabled
IGMP Version
Internet Group Management Protocol (IGMP)
Last Reporter
165.87.34.100
165.87.31.100
Interfaces.
2). Lowering this value decreases leave
372