User Roles - Dell Z9500 Configuration Manual

• Security Administrator (secadmin): This user role can control the security policy across the systems that are within a domain
or network topology. The security administrator commands include FIPS mode enablement, password policies, inactivity
timeouts, banner establishment, and cryptographic key operations for secure access paths.
• System Administrator (sysadmin). This role has full access to all the commands in the system, exclusive access to
commands that manipulate the file system formatting, and access to the system shell. This role can also create user IDs and

user roles.

The following summarizes the modes that the predefined user roles can access.
Role Modes
netoperator
netadmin Exec Config Interface Router IP Route-map Protocol MAC
secadmin Exec Config Line
sysadmin Exec Config Interface Line Router IP Route-map Protocol MAC
User Roles
This section describes how to create a new user role and configure command permissions and contains the following topics.
• Creating a New User Role
• Modifying Command Permissions for Roles
• Adding and Deleting Users from a Role
Creating a New User Role
Instead of using the system defined user roles, you can create a new user role that best matches your organization. When you
create a new user role, you can first inherit permissions from one of the system defined roles. Otherwise you would have to
create a user role's command permissions from scratch. You then restrict commands or add commands to that role. For more
information about this topic, see
NOTE: You can change user role permissions on system pre-defined user roles or user-defined user roles.
Important Points to Remember
Consider the following when creating a user role:
• Only the system administrator and user-defined roles inherited from the system administrator can create roles and user
names. Only the system administrator, security administrator, and roles inherited from these can use the "role" command to
modify command permissions. The security administrator and roles inherited by security administrator can only modify
permissions for commands they already have access to.
• Make sure you select the correct role you want to inherit.
• If you inherit a user role, you cannot modify or delete the inheritance. If you want to change or remove the inheritance,
delete the user role and create it again. If the user role is in use, you cannot delete the user role.
1 Create a new user role
CONFIGURATION mode
userrole name [inherit existing-role-name]
2 Verify that the new user role has inherited the security administrator permissions.
Dell(conf)#do show userroles
EXEC Privilege mode
Modifying Command Permissions for Roles.
Security 719