Wireless Commands - D-Link DAP-3220 Reference Manual

Fundamental
Config Commands:
Select WLAN Adapter to configure. DWL-3220AP only WLAN 1 is
config wlan
available for configuration. This command is not necessary.
Find Commands:
find bss Perform Site Survey, Wireless service will be disrupted
find channel Channel spanning to select the Preferred Channel
Perform Site Survey including Super G and Turbo, Wireless service will
find all
be disrupted
IGMP Command:
igmp state Display IGMP snooping state
igmp enable Enable IGMP snooping
igmp disable Disable IGMP snooping
igmp dump Display IGMP MDB dump list
igmp getrssi Display IGMP snooping rssi threshold
igmp setrssi Set IGMP snooping rssi threshold
igmp getportagingtime Display IGMP snooping port aging time
igmp setportagingtime Set IGMP snooping port aging time
Get Command:
get apmode Display current AP Mode
get ssid Display Service Set ID
get ssidsuppress Display SSID Suppress Mode as enabled or disabled
get station Display Client Station Connection Status
get wdsap Display WDS Access Point List
get remoteAp Display Remote AP's Mac Address
Display Association Table that indicates the information of associated
get association
client devices
get autochannelselect Display state of Auto Channel Selection feature (enabled, disabled)
get frequency Display Radio Frequency (MHz)
get channel Display Radio Frequency (MHz) and Channel Designation
802.11 b/g Access Point Command Line Interface Manual
Function
Function
Function
9
5
W
IRELESS
Syntax
config wlan [0:1]
find bss
find channel
find all
Syntax
igmp state
igmp enable
igmp disable
igmp dump
igmp getrssi
igmp setrssi <0 - >
igmp getportagingtime
igmp setportagingtime <0 - >
Syntax
get apmode
get ssid
get ssidsuppress
get station
get wdsap
get remoteAp
get association
get autochannelselect
get frequency
get channel
C
OMMANDS