Operation; Disposal Information - Dyson cinetic big ball Operating Manual

Hide thumbs Also See for cinetic big ball:
Table of Contents

Advertisement

Available languages

Available languages

EN
USING YOUR DYSON APPLIANCE
PLEASE READ THE 'IMPORTANT SAFETY INSTRUCTIONS' IN THIS DYSON
OPERATING MANUAL BEFORE PROCEEDING.
CARRYING THE APPLIANCE
Carry the appliance by the main handle on the body.
Do not press the cyclone release button or shake the appliance when carrying or
the cyclone could disengage, fall off and cause injury.

OPERATION

Always extend the cable fully to the red tape before use.
Plug the appliance into the mains electricity supply.
To switch 'ON' or 'OFF' press the red power button, located as shown.
After use: Unplug, push the cable retract button firmly until cable has
fully retracted.
Switch 'OFF' the appliance and unplug before:
– changing tools
– removing the hose.
MUSCLEHEAD FLOOR TOOL WITH
SUCTION CONTROL
Your appliance has a Musclehead floor tool with suction control. This cleaner
head is used for testing with the European Regulations: No. 665/2013 and
No. 666/2013 and testing shall be performed in Max mode.
EASY MODE
Reduced push force for effortless cleaning.
For vacuuming of lightly soiled carpets, rugs and hard flooring.
Your appliance is pre-set to this level of suction when you take it out of the box.
MAX MODE
Maximum suction for powerful dust and dirt removal.
For vacuuming durable floor coverings, hard floors and heavily soiled carpets
and rugs.
To switch to this setting, move the suction control slider on top of the cleaner
head as shown.
CAUTION: The suction of this mode can damage delicate flooring. Before
vacuuming, check the flooring manufacturer's cleaning recommendations.
If the suction power of Max mode prevents easy manoeuverability, switch to
Easy mode.
LOOKING AFTER YOUR DYSON APPLIANCE
Do not carry out any maintenance or repair work other than that shown in this
Dyson Operating Manual, or advised by the Dyson Helpline.
Only use parts recommended by Dyson. If you do not this could invalidate
your guarantee.
Store the appliance indoors. Do not use or store it below 3°C (37.4°F). Ensure
the appliance is at room temperature before operating.
Clean the appliance only with a dry cloth. Do not use any lubricants, cleaning
agents, polishes or air fresheners on any part of the appliance.
If used in a garage, always wipe the base plate and ball with a dry cloth
after vacuuming to clean off any sand, dirt, or pebbles that could damage
delicate floors.
VACUUMING
Do not use without the clear bin and cyclone in place.
Do not use on rubble, ash or plaster. This appliance is designed only for
domestic use to remove household dirt, hair and allergens. The appliance is not
designed to be used on:
– debris produced from activities such as DIY, building or similar tasks
– larger types and quantities of dust or debris, such as soot and sawdust.
These materials may harm the appliance and may void your guarantee.
Fine dirt such as flour should only be vacuumed in very small amounts.
Do not use the appliance to pick up sharp hard objects, small toys, pins, paper
clips, etc. They may damage the appliance.
When vacuuming, certain carpets may generate small static charges in the
clear bin or wand. These are harmless and are not associated with the mains
electricity supply. To minimise any effect from this, do not put your hand or
insert any object into the clear bin unless you have first emptied it and rinsed it
out with cold water (see 'Cleaning the clear bin').
Do not work with the appliance above you on the stairs.
Do not put the appliance on chairs, tables, etc.
Before vacuuming highly polished floors, such as wood or lino, first check that
the underside of the floor tool and its brushes are free from foreign objects that
could cause marking.
Do not push hard with the floor tool when vacuuming, as this may
cause damage.
EMPTYING THE CLEAR BIN
Empty as soon as the dirt reaches the level of the MAX mark – do not overfill.
Switch 'OFF' and unplug before emptying the clear bin.
To remove the cyclone and clear bin unit, push the red button on the top of the
carrying handle, as shown.
To release the dirt, firmly push the red bin release button.
– The bin will slide down, cleaning the shroud as it goes.
– The bin base will then open.
The bin base will not open if the red button is not pushed down fully.
To minimise dust/allergen contact when emptying, encase the clear bin tightly in
a plastic bag and empty.
Remove the clear bin carefully from the bag.
Seal the bag tightly, dispose as normal.
Close the clear bin by pushing the bin base upwards until it clicks into place.
Push the bin base clip firmly until it clicks into position to ensure that the base is
securely sealed.
Align the base of the clear bin with the air hose inlet and then click back
into place.
32
CLEANING THE CLEAR BIN (OPTIONAL)
In the event that it is necessary to clean the clear bin:
Remove the cyclone and clear bin and push the red bin base release button.
Pull the silver catch behind the red bin release button and slide the clear bin off
the spine on the cyclone.
Clean the clear bin with cold water only.
Do not use detergents, polishes or air fresheners to clean the clear bin.
Do not put the clear bin in a dishwasher.
Do not immerse the cyclone in water or pour water into the cyclones.
Ensure the clear bin is completely dry before replacing.
To refit the clear bin:
– Insert the spine into the bin runner
– Push upwards until it clicks and then continue pushing until it slides home.
Close the clear bin by pushing the bin base upwards. Ensure that the bin base
clicks and the clip is securely in place.
BLOCKAGES – THERMAL CUT-OUT
This appliance is fitted with an automatically resetting thermal cut-out.
If any part becomes blocked the appliance may overheat and automatically
cut-out.
If this happens, follow the instructions below in 'Looking for blockages'.
NOTE: Large items may block the tools or wand inlet. If this happens, do not
operate the wand release catch. Switch 'OFF' and unplug. Failure to do so could
result in personal injury.
2
1
3
LOOKING FOR BLOCKAGES
Switch 'OFF' and unplug before looking for blockages. Failure to do so could
result in personal injury.
Leave to cool down for 1-2 hours before looking for blockages.
Beware of sharp objects when checking for blockages.
Clear any blockage before restarting.
Refit all parts securely before using.
Clearing blockages is not covered by your guarantee.

DISPOSAL INFORMATION

Dyson products are made from high grade recyclable materials. Recycle
where possible.
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems or contact
the retailer where the product was purchased. They can take this product for
environmental safe recycling.
GUARANTEE TERMS AND CONDITIONS
DYSON CUSTOMER CARE
THANK YOU FOR CHOOSING TO BUY A DYSON APPLIANCE
After registering your 5 year guarantee, your Dyson appliance will be covered
for parts and labour for 5 years from the date of purchase, subject to the terms
of the guarantee. If you have any questions about your Dyson appliance, call the
Dyson Helpline with your serial number and details of where/when you bought
the appliance. Most questions can be solved over the phone by one of our
trained Dyson Helpline staff.
Alternatively, visit www.dyson.com for online help, general tips and useful
information about Dyson.
If your Dyson appliance needs a service, call the Dyson Helpline so we can
discuss the available options. If your Dyson appliance is under guarantee, and
the repair is covered, it will be repaired at no cost.
Your serial number can be found on your rating plate which is on the base of
the appliance.
PLEASE REGISTER AS A DYSON
APPLIANCE OWNER
To help us ensure you receive prompt and efficient service, please register as a
Dyson appliance owner. There are three ways to do this:
Online at www.dyson.co.uk/register (UK) or www.dyson.ie/support (ROI).
Telephone the Dyson Helpline.
Complete the enclosed form and post it to us.
This will confirm ownership of your Dyson appliance in the event of an insurance
loss, and enable us to contact you if necessary.
LIMITED 5 YEAR GUARANTEE
TERMS AND CONDITIONS OF THE DYSON 5 YEAR LIMITED GUARANTEE.
WHAT IS COVERED
The repair or replacement of your Dyson machine (at Dyson's discretion) if it is
found to be defective due to faulty materials, workmanship or function within
5 years of purchase or delivery (if any part is no longer available or out of
manufacture Dyson will replace it with a functional replacement part).
Where this machine is sold outside of the EU, this warranty will only be valid if
the appliance is used in the country in which it was sold.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents