Table of Contents
Advertisement
Cleaning the Pinch and Feed Rollers
To clean the pinch and feed rollers:
1.
Turn off the printer and open the supply cover.
Remove the supplies. See "Removing Supplies" in Chapter 3 for
2.
more information.
3.
Turn the platen roller with your fingers while running a dry, lint-free
cloth across the pinch and feed rollers as they turn. Make sure the
rollers are clean all the way around. If necessary, use a cloth
dampened slightly with distilled water.
4.
Reload the supplies after the printer dries.
Cleaning the Sensors
To clean the on-demand sensor:
1.
Turn off the printer and open the supply cover.
2.
Remove the supplies. See "Removing Supplies" in Chapter 3 for
more information.
3.
Open the label deflector by
gently pressing down with
two fingers.
4.
Clean the on-demand
sensor with a soft cloth
moistened with distilled
water.
Reload the supplies, close
5.
the label deflector and
supply cover.
5-4 Operator's Handbook
On-Demand
Sensor
Advertisement
Table of Contents
