Using The Operator Data Entry Form - Paxar Monarch DOS-based Pathfinder Ultra System 6035 User Manual

U s i n g t h e O p e r a t o r D a t a E n t r y F o r m
After you create a format, fill out the operator data entry form. This form can
be used as an instruction sheet for your operators to follow while they print
labels. Record the data entry prompts that the operator will see when using
the printer.
Follow these steps to record the data entry procedures.
1.
Format Name
2.
Supply Type
3. Supply Size
4.
Purpose
5. Print Sample
6. Prompt
7. Response
8.
Special Instructions
Blank forms are provided at the end of the chapter for you to copy.
Enter the Format Name in the upper right corner of
the form.
Enter information about the supply type the Operator
must use.
Enter the supply size to use.
Enter the purpose of the label on the next line. For
example, you can write standard label or 25%
markdowns.
Apply a sample of the label.
Enter the first data entry prompt in the empty box at
left.
Enter the response for the prompt. Continue entering
prompts and responses until you reach the end of the
format.
In the "Special Instructions" section at the bottom of
the form, record any special instructions to the
Operator. For example, you can tell them to load the
labels for peel mode.
Getting Started 2-9