b. Remove the screws that secure the eDP connector [2].
c. Lift and remove the bracket from the connector [3].
d. Disconnect the eDP cable [4].
Installing the display cable
1.
Install the eDP connector and place the bracket in its slot.
2.
Tighten the screws that secure the eDP connector to the system board.
3.
Route the cable through the routing channels.
4.
Install:
a.
heatsink
b.
WWAN card
c.
WLAN card
d.
antenna bracket
e.
docking board
f.
base cover
g.
battery
5.
Follow the procedures in
Removing the display assembly
1.
Follow the procedures in
2.
Remove:
a.
battery
b.
base cover
c.
docking board
d.
antenna bracket
40
After Working Inside Your
Before Working Inside Your
computer.
Computer.