Attachment 11: Diagnosis And Parameterisation (Parameter Setting); Terminal Module Em18 Te And User Terminal Ht18 - Siemens AT18 Operating Instructions Manual

Operating Manual - Elevator Door Operation AT18

15.11 Attachment 11: Diagnosis and parameterisation (Parameter setting)

For the diagnosis and setting of the parameters the terminal module, the user terminal or the AT
Frontend PC can equally be used.
These tools are available as an option (see attachment).
The terminal module (option) is situated under the housing lid. The user terminal and the USB
adapter of the AT Frontend PC can be connected to X8 of the control unit with the cable belonging
to it. The buttons of the tools have identical identification and meaning.
Accept key, jump to next menu below
Escape key, jump back to menu above
ESC
Menu selection key, increase of a parameter value
Menu selection key, reducing of a parameter value
Changes to the parameter can be done in the "MAIN MENU QUICK ALIGNMENT
Setting" menu and in the 'MAIN MENU TOTAL ALIGNMENT
For that purpose the desired parameter is selected with the " " or " " key and activated with the
accept key " " for the setting (parameter value flashes). With the aid of the relevant key (see
above) the parameter value can be increased or reduced. The taking over/acceptance of the value
takes place by renewed pressing of the accept button.
15.11.1 Terminal module EM18 TE and the user terminal HT18
Photo 13
40
Profile Parameter" menu.
Photo 14
Parameter