Suggested Machine Installations - Asko DWC5926 XL Operating Instructions Manual

Suggested machine installations

The dishwasher can be installed built-in, completely freestanding
or partially built-in. Check that there is an air gap of 3 mm between
the underside of the worktop and the top edge of the dishwasher,
as well as behind the dishwasher when it is built in.
The interior design around the dishwasher should be adapted
for commercial use to enable evacuation of the hot condensation.
A. Built-in
The dishwasher is intended for built-in installation under a work-
top. The built-in measurements are shown in the illustration. The
cable and hose hole does not need to be larger than 38 mm in
diameter. Increase the cable and hose hole to 50 mm in diameter
if the dishwasher is also going to be connected to an automatic
dosing system. Make sure that the cable and hose hole's edges
are smooth and will not damage the drainage and inlet hoses or
the power cable.
[mm]
*Remove locking nuts for an installed height
of 820-821 mm.
B. Freestanding
A freestanding dishwasher must be fitted with anti-tip brackets.
This comprises two brackets, which are screwed into place as
illustrated.
The dishwasher is then pushed in so that the brackets engage
the rear feet. Now the dishwasher will not topple if pressure is
put on the open door. If the dishwasher is installed completely
on its own, side panels and a worktop must both be fitted. Acces-
sories can be purchased where you bought the dishwasher.
WARNING!
A completely freestanding dishwasher must be fitted with anti-
tip brackets.
560
Min. 560
C. Partially built-in
If the dishwasher is located so that one of its sides is visible, a
side panel must be fitted. Accessories can be purchased where
you bought the dishwasher.
Attach the light shielding film
Mount the light shielding film (enclosed documents) above the
touch buttons below the worktop. The purpose of the light
shielding film is to get the touch buttons to function optimally,
and to protect the worktop from moisture.
NOTE!
The surface on which the light shielding film is affixed must be
clean and dry.
Attach the door seal
1
Adjust the height and slide the
dishwasher into place
1 Start by measuring the height from the floor to the bottom
edge of the worktop.
2 Measure the height from the floor to the top edge of the dish-
washer.
3 Adjust all feet by turning them clockwise to raise or anticlock-
wise to lower the dishwasher.
24 mm
4 Check that there is an air gap of 3 mm between the underside
of the worktop and the top edge of the dishwasher, as well as
behind the dishwasher.
5 Tighten the lock nuts (lock nut) on the rear feet.
2
21