Removing Bobbin Case From Shuttle; Inserting Bobbin Into Bobbin Case - Singer 6660 Instruction Manual

REMOVING BOBBIN CASE FROM SHUTTLE

1. Raise the needle to its highest position by rotating the
hand wheel toward you (counter-clockwise).
2. Open the bobbin access cover by pulling it down.
With your fingers, pull open the bobbin case latch as
shown, and take out the bobbin case from the shuttle.
3. Release the latch, and bobbin will drop out of the case.

INSERTING BOBBIN INTO BOBBIN CASE

1. Hold the bobbin in your right hand with the thread
running clockwise.
2. Insert the bobbin into the case with about 4" (10 cm) of
thread showing outside the case.
3. Pull the thread through the slit in the case and then
in place.
4. Keep about 4" (10 cm) of thread showing outside the
case.
16
1
2
3
1
3
2