Technical Data - Hilti te 4-a22 Operating Instructions Manual

LEDs light constantly
LED 1, 2, 3, 4
LED 1, 2, 3
LED 1, 2
LED 1
-
NOTE
Indication of the charge status is not possible while the power tool is in operation or immediately after operation. If the
battery charge status LEDs blink, please refer to the information given in section 9.

4 Technical data

Right of technical changes reserved.
Power tool
Rated voltage (DC voltage)
Weight in accordance with EPTA procedure 01/2003
Rated speed under no load n₀
Single impact energy in accordance with EPTA proced-
ure 05/2009
Drilling diameter range in concrete/masonry (hammer
drilling)
Drilling diameter range in wood module-head bit)
Drilling diameter range in wood (auger bit)
Drilling diameter range in metal module metal)
NOTE
The sound pressure and vibration values given in these instructions have been measured in accordance with a
standardized test and may be used to compare one electric tool with another. They may be used for a preliminary
assessment of exposure. The data given represents the main applications of the electric tool. However, if the electric
tool is used for different applications, with different accessories or is poorly maintained, the data may vary. This may
significantly increase exposure over the total working period. An accurate estimation of exposure should also take into
account the times when the tool is switched off, or when it is running but not actually being used for a job. This may
significantly reduce exposure over the total working period. Identify additional safety measures to protect the operator
from the effects of noise and/or vibration, for example: maintain the electric tool and accessories, keep the hands
warm, organization of work patterns.
Noise and vibration information (measured in accordance with EN 60745‑2‑6):
Typical A-weighted sound power level, L
Typical A-weighted emission sound pressure level., L
Uncertainty for the given sound level, K
Triaxial vibration values (vibration vector sum)
Hammer drilling in concrete, a
Drilling in metal, a
h, D
Uncertainty (K) for triaxial vibration values
NOTE
With the B22/1.6Ah battery, performance of the tool is reduced.
LEDs blink
-
-
-
-
LED 1
WA
pA
h, HD
Charge status C
C ≧ 75 %
50 % ≦ C < 75 %
25 % ≦ C < 50 %
10 % ≦ C < 25 %
C < 10 %
TE 4‑A22
21.6 V
3.3 kg
1,090/min
2.0 J
5...16 mm
3...20 mm
Max. 14 mm
3...10 mm
99 dB (A)
88 dB (A)
3 dB (A)
measured in accordance with EN 60745‑2‑6
11 m/s²
5.5 m/s²
1.5 m/s²
en
5