Firstech 2W902R-SP User Manual page 12

Advanced System Functions
This remote has the ability to operate a 2nd vehicle with the same system.
Note: When in 2nd Car Mode that your LED will flash blue when the buttons are tapped. Hold buttons
Option Menu. Tap the Trunk Button to turn 2nd Car Mode on. Your remote will chirp once for on and twice for off. The remote's LED will illuminate
blue confirming that 2nd car mode is activated. The remote will remain in 2nd Car Mode until you hold the
Remote Option Menu and tap the Trunk Button. The remote will beep twice and you must hold the Trunk and Key/Start buttons
save the Remote Option Menu changes.
IMPORTANT: 2nd car mode requires the remote to be programmed to a 2nd vehicle that is equipped with the same remote kit.
By Firstech, LLC 22
Advanced System Functions
The RPS is an optional feature. The car call/RPS feature uses a small sensor that is mounted on the inside of your windshield.
for 2.5 seconds to enter the Remote
RPS Touch (Remote Paging Sensor)
The new RPS touch has multiple features including: remote paging, 4 digit pin unlock/disarm, and arm/lock. All features are operated with a simple touch of the sensor.
buttons for 2.5 seconds, enter the
Please have your installer program Option 3-16 to Setting 2.
to
RPS Touch and car call functions do not require programming, however in order to unlock/disarm your vehicle you must program a 4 digit passcode using the instructions below:
STEP 1: Choose your RPS Touch 4 digit code. 0 is not available.
STEP 2: Turn ignition to the ON position and leave driver s door open.
STEP 3: Hold your finger over the Red Circle icon for 2.5 seconds.
STEP 4: When the siren chirps and LEDs flash in a circular pattern, tap on your first number. (Hold the number for 2.5 seconds to choose 6 through 10.) After
choosing your first number you will get one siren chirp and LEDs will flash in a circular pattern.
STEP 5: Repeat Step 4 until all four digits are set. You will get 1 siren chirp and 1 parking light flash. Repeat Steps 2 - 5 if you get 3 chirps and light flashes. Your
RPS Touch is now programmed.
Alarm rearm and lock
To rearm hold your finger on the Red Circle for 2.5 seconds.
Alarm disarm and unlock
To disarm hold your finger over the Red Circle for 2.5 seconds. Once the LEDs start their circular pattern, enter your 4 digit code. (Refer to Step 4 above.) Two
seconds after entering the 4th digit, your system will disarm.
23 By Firstech, LLC