Firstech 2W902R-SP User Manual page 10

General System Functions
Your system is equipped with two additional outputs that can be configured to control windows, open power sliding doors, open a power sliding moon
roof, or even turn on a rear defroster. These outputs can be configured for pulsed, timed or latched settings. Your authorized Firstech dealer can set these
outputs up accordingly. Using auxiliary outputs to control additional vehicle functions will require additional parts and can be rather labor extensive.
Tap the Function button for a half second followed by the Trunk button
second followed by the Key/Start button to trigger auxiliary output 2. The remote will beep once and parking lights flash, indicating that the auxiliary
output(s) have been triggered.
By default, the system is in secure auxiliary mode, which requires you to tap the Key/Start button for a half second prior to triggering auxiliary 1 or 2. To
turn off secure auxiliary, ask your authorized Firstech dealer to turn on Option 4-5 to setting II
Upon lock/arm and unlock/disarm, you can eliminate vehicle's audible confirmation by muting the siren. Normally, the siren will chirp once to indicate
the system is locked/armed and twice to indicate the system is unlocked/disarmed. To mute the siren tap
second.
IMPORTANT: Even when the siren is muted, it will still go off in the event the alarm is triggered.
By Firstech, LLC 18
to trigger auxiliary output 1. Tap the Function button for a half
buttons simultaneously for a half
General System Functions
To silent your remote you must turn on Remote Mute on;
STEP 1: Enter remote programming mode by holding the Trunk and Key/Start buttons
beep 3 times and the LED will flash purple indicating that you have successfully entered programming mode.
STEP 2 : Tap the Unlock button. The LED will flash blue indicating that silent mode is on. Tap the Unlock button again to turn Remote Mute off.
Two chirps and red LED flashes indicates Remote Mute is off.
STEP 3: Exit remote programming by holding down the Trunk and Key/Start buttons
beep indicating that you have successfully exited
Hold the Lock and Unlock buttons simultaneously for 2.5 seconds to turn the shock sensor on and off. The remote will beep twice and LED flash
twice to confirm the shock sensor is off. The remote will beep once and LED flash once to confirm the shock sensor is on.
IMPORTANT: Turning off the shock sensor also turns off any optional sensors.
Adjusting the shock sensor sensitivity is done at the actual sensor, which is generally mounted somewhere under the vehicle's dashboard. The higher the
number on the dial means greater sensitivity to impact. The recommended dial setting for most vehicles is somewhere between 2 & 4. If you are testing
your sensor, please note that the shock sensor does not recognize impact for 30 seconds after the system has been armed.
simultaneously for 2.5 seconds. The remote will
simultaneously for 2.5 seconds. The remote will
19 By Firstech, LLC