Save These Instructions - Dirt Devil F91 Owner's Manual

• Hold plug when rewinding onto cord reel. Do not allow plug to whip when
rewinding.
• Use only as described in this manual. Use only manufacturer's recommended
attachments and products.
• Always turn off this appliance before connecting or disconnecting either hose,
motor ized nozzle or turbo floor nozzle.
• The hose contains electrical wires. Avoid picking up sharp objects. If hose appears
damaged, cut, punctured, or wires are exposed, unplug unit and discontinue use.
Do not attempt to repair damaged hose, take to an authorized service center for
repair.
• Any other servicing should be done by an authorized service represenative.
• If appliance is not working as it should, has been dropped, damaged, left
outdoors, or dropped into water, take it to a service center prior to continuing use.
CAUTION-TO REDUCE RISK OF DAMAGE:
• Avoid picking up hard, sharp objects with this product as they may cause damage.
• Store appropiately indoors in a dry place. Do not expose machine to freezing
temperatures.
• Do not use sharp objects to clean our hose as they can cause damage.
• Do not allow power nozzle with brushroll running to sit in one location for an
extended period of time, as damage to floor can result.

SAVE THESE INSTRUCTIONS

WARNING:
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider
than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to
install the proper outlet. Do not change the plug in any way.
An internal thermal protector has been designed into your cleaner to protect it from
overheating. When the thermal protector activates the cleaner will stop running. If this
happens proceed as follows:
1. Turn cleaner OFF and disconnect it from the electrical outlet.
2. Empty dirt cup.
3. Inspect the nozzle, inlet, nozzle connector, hose connector, hose, dirt cup
inlet, cyclonic filter, rinsable filter, and HEPA filter for any obstructions.
Clear obstructions if present.
4. When cleaner is unplugged and motor cools for 30 minutes, the thermal
protector will deactivate and cleaning may continue.
If the thermal protector continues to activate after following the above steps, your cleaner
may need servicing.
3