Woods TS1680 Operator's Manual page 9

ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!
(Safety Rules continued from previous page)
TRANSPORTATION
 The maximum transport speed for towed and
semi-mounted machines is 20 mph (32 km/h).
Regardless of the maximum speed capability of the
towing tractor, do not exceed the implement's max-
imum transport speed. Doing so could result in:
• Loss of control of the implement and tractor
• Reduced or no ability to stop during braking
• Implement tire failure
• Damage to the implement or its components.
 Use additional caution and reduce speed when
under adverse surface conditions, turning, or on
inclines.
 Never tow this implement with a motor vehicle.
 Do not operate PTO during transport.
 Do not operate or transport on steep slopes.
 Do not operate or transport equipment while
under the influence of alcohol or drugs.
 Always comply with all state and local lighting
and marking requirements.
 Never allow riders on power unit or attachment.
MAINTENANCE
 Before dismounting power unit or performing
any service or maintenance, follow these steps:
disengage power to equipment, lower the 3-point
hitch and all raised components to the ground,
operate valve levers to release any hydraulic pres-
sure, set parking brake, stop engine, remove key,
and unfasten seat belt.
 Before working underneath, raise mower, install
transport lock, and block mower securely. Hydrau-
lic system leak down and failure of mechanical or
hydraulic system can cause equipment to drop.
 Do not modify or alter or permit anyone else to
modify or alter the equipment or any of its compo-
nents in any way.
 Your dealer can supply original equipment
hydraulic accessories and repair parts. Substitute
parts may not meet original equipment specifica-
tions and may be dangerous.
 Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.
(Rev. 8/30/2013)
TS1680 Safety Rules (6/29/2007)
SAFETY RULES
 Do not allow bystanders in the area when oper-
ating, attaching, removing, assembling, or servic-
ing equipment.
 Never go underneath equipment (lowered to the
ground or raised) unless it is properly blocked and
secured. Never place any part of the body under-
neath equipment or between moveable parts even
when the engine has been turned off. Hydraulic
system leak down, hydraulic system failures,
mechanical failures, or movement of control levers
can cause equipment to drop or rotate unexpect-
edly and cause severe injury or death. Follow Oper-
ator's Manual instructions for working underneath
and blocking requirements or have work done by a
qualified dealer.
 Make sure attachment is properly secured,
adjusted, and in good operating condition.
 Keep all persons away from operator control
area while performing adjustments, service, or
maintenance.

Make certain all movement of equipment com-
ponents has stopped before approaching for ser-
vice.
 Frequently check blades. They should be sharp,
free of nicks and cracks, and securely fastened.
 Do not handle blades with bare hands. Careless
or improper handling may result in serious injury.
 Your dealer can supply genuine replacement
blades. Substitute blades may not meet original
equipment specifications and may be dangerous.
 Tighten all bolts, nuts, and screws to torque
chart specifications. Check that all cotter pins are
installed securely to ensure equipment is in a safe
condition before putting unit into service.
 Make sure all safety decals are installed.
Replace if damaged. (See Safety Decals section for
location.)
 Make sure shields and guards are properly
installed and in good condition. Replace if dam-
aged.
 Do not disconnect hydraulic lines until machine
is securely blocked or placed in lowest position
and system pressure is released by operating
valve levers.
 Leak down or failure of mechanical or hydraulic
system can cause equipment to drop.
(Safety Rules continued on next page)
Safety 9