Vga Connector Mapping - Dell Embedded Box PC 3000 Installation And Operation Manual

Features
5 RS232/RS485 port one (configurable in the BIOS)
6 12-26V DC power port
7 Wireless antenna port one
8 Wireless antenna port two
9 Remote power switch
10 RS232/RS485 port three (configurable in the
BIOS)
11 USB 2.0 port
12 USB 2.0 port
13 Network port two
14 CANbus port (optional)
15 DisplayPort
16 Mobile broadband antenna port two
17 Mobile broadband antenna port one
1 Connections made to these ports must use SELV circuits and the wire (26 AWG-18 AWG) must have Double Insulation (DI) or Reinforced Insulation (RI) to protect it from
all hazardous voltages. Torque the screws at 2.88 kg-cm (2.5 lb-in) to secure the wire to the connector.

VGA connector mapping

Pin Signal
1 RED
2 GREEN
3 BLUE
4 NC
1
Pin
6
7
8
9
Connect a RS232/RS485 cable to the Embedded Box PC. For
more information, see RS232/RS485
Connect a 12-26V DC power cable for supplying power to the
Embedded Box PC. For more information about the physical
dimensions of the DC power port, see
Connect a wireless antenna to increase the range and strength of
the wireless signals.
Connect a wireless antenna to increase the range and strength of
the wireless signals.
Install a remote power switch.
Connect a RS232/RS485 cable to the Embedded Box PC. For
more information, see RS232/RS485
Connect a USB enabled device. Provides data transfer speeds up
to 480 Mbps.
Connect a USB enabled device. Provides data transfer speeds up
to 480 Mbps.
Connect an Ethernet (RJ45) cable for network access. Provides
data transfer speeds up to 10/100/1000 Mbps.
Connect to a CANbus port enabled device or dongle. For more
information, see CANbus connector mapping.
Connect a monitor or another DisplayPort enabled device.
Provides video and audio output.
Connect a mobile broadband antenna to increase the range and
strength of the mobile broadband signals.
Connect a mobile broadband antenna to increase the range and
strength of the mobile broadband signals.
Signal Pin
GND 11
GND 12
GND 13
+5V 14
connector mapping.
DC power port.
connector mapping.
Signal
NC
DDCDAT
HSYNC
VSYNS
7