Fujitsu AS*7A Technical Manual page 157

11. REMOTE CONTROL UNIT INSTALLATION
(1) Check that the indoor unit correctly
receives the signal from the remote
control unit, then install the remote
control unit holder.
(2) Select the remote control unit holder
selection site by paying careful atten-
tion to the following:
Avoid places in direct sunlight.
Select a place that will not be affect-
ed by the heat from a stove, etc.
1. REMOTE CONTROL UNIT HOLDER INSTAL-
LATION
Install the remote control unit so that the front is fac-
ing the photocell. (Fig. 42)
Fig. 42
Remote control unit
Install the remote control unit with a distance of 7 m
between the remote control unit and the photocell
as the criteria. However, when installing the remote
control unit, check that it operates positively.
Install the remote control unit holder to a wall, pillar,
etc. with the tapping screw (Fig. 43).
Fig. 43
For use as Handy Type
Insert
Screws
1. Mount the 2. Set the Remote
Holder. ControlUnit.
For use as Wall Fixing Type
Insert
Screws
1. Mount the 2. Set the Remote
Holder. ControlUnit.
Slide up
3. To remove the
RemoteControl Unit
(when useat hand.)
Screw
Slide
3. Attach the unit to
the holder as shown.
2. REMOTE CONTROL UNIT CODE SWITCHING
Fig. 42
Remote control unit
A B C D
Remote control unit
signal selector switch
Confirm the remote control unit signal selector
switch selection and printed circuit board setting.
If these are not confirmed, the remote control unit
cannot be operated for the air conditioner.
Jumper wire
JM 2
Connect
Connect Disconnect
Disconnect
Disconnect Disconnect
After setting the remote control unit signal selector
switch, press the ACL button.
– – – 156 –
Indoor unit
Printed circuit board
JM1
JM2
JM3
AUTORESTART
REMOCON 2
REMOCON 1
A B C D
Table 5
Remote control unit
signal selector switch
JM 3
Connect A (Primary setting)
B
Connect C
D
ACL button