Troubleshooting - Bose AR1 Owner's Manual

English Dansk
Your Bose
• Room code
Make sure the system, amplifier, or powered speaker room
code setting matches that of the remote you are using in the
expansion room.
For information on room code settings and how to change
them, refer to the owner's guide that came with your Bose
product.

Troubleshooting

Problem What to do
No sound •
•
Deutsch Español
link expansion room product
®
For both the AL8 transmitter and AR1 receiver, make sure:
– the audio source is plugged in, turned on, and working.
– both the transmitter and receiver are properly plugged into
functioning AC power outlets. Refer to Steps 3 and 4 in
"Connecting to a Bose link-compatible product" on page 5.
– the Bose link A cable is securely connected at both ends.
Refer to "Connecting to a Bose link-compatible product" on
page 5.
– the small connector end of the power cord is inserted firmly
into the AC Power jack on the connection panel and the
power pack is plugged securely into a working AC outlet.
– the Setup code switches on the connection panel of the
transmitter and the receiver are set identically. There are four
options: 1 & 2 up; 1 & 2 down; 1 up & 2 down; 1 down & 2 up.
– the Status LEDs are lit a solid green to indicate solid
communication between the two parts. If not, refer to the
next problem in this table.
For the expansion room products, make sure:
– the system, amplifier, or powered speaker is plugged in and
turned on. On an SA-2 or SA-3 amplifier in that room, make
sure the status LED is lit to indicate the amplifier is working.
– the room code is set on the Bose link remote control or
®
PERSONAL music center II to match the room codes on
the amplifier or powered speaker and is unique to this
expansion room.
– the house code is set on the Bose link remote control or
®
PERSONAL music center II to match the house code of the
®
LIFESTYLE system in the main room.
Français Italiano
C
Nederlands Svenska
ONFIRMING OPERATION
® link
9