Mercedes-Benz C-CLASS CABRIOLET Operator's Manual page 88

Side windows
86
To open all side windows fully: press
X
switch : beyond the pressure point.
To close all side windows: pull and hold
X
button :.
Using KEYLESS-GO
G
WARNING
When using the convenience closing feature,
parts of the body could be trapped in the clos-
ing area when a side window is being closed.
There is a risk of injury.
Observe the complete closing procedure
when the convenience closing feature is oper-
ating. Make sure that no body parts are in
close proximity during the closing procedure.
The SmartKey must be outside the vehicle. All
the doors must be closed.
Convenience closing feature: touch
X
recessed sensor surface : on the door han-
dle until the side windows are fully closed.
i
Make sure you only touch recessed sensor
surface :.
To interrupt convenience closing: release
X
recessed sensor surface : on the door han-
dle.
Problems with the side windows
G
WARNING
If you close a side window again immediately after it has been blocked or reset, the side window
closes with increased or maximum force. The reversing feature is then not active. Parts of the
body could be trapped in the closing area in the process. This poses an increased risk of injury or
even fatal injury.
Resetting the side windows
If a side window can no longer be closed fully,
you must reset it.
Close all the doors.
X
Turn the SmartKey to position 1 or 2 in the
X
ignition lock.
Close the soft top (
X
Y
Pull the corresponding switch on the door
X
control panel until the side window is com-
pletely closed ( page 85).
Y
Hold the switch for an additional second.
X
If the side window opens again slightly:
Immediately pull the corresponding switch on
X
the door control panel until the side window is
completely closed (
Y
Hold the switch for an additional second.
X
If the respective side window remains closed
X
after the button is released, then it has been
set correctly. If this is not the case, repeat the
steps above.
page 88).
page 85).