Table of Contents
Advertisement
must be positioned vertically, directly under
the jacking point of the vehicle.
!
Only position the jack at the appropriate
jacking point of the vehicle. Otherwise, you
could damage the vehicle.
Observe the following when raising the vehi-
cle:
To raise the vehicle, only use the vehicle-spe-
R
cific jack that has been tested and approved
by Mercedes-Benz. If used incorrectly, the
jack could tip over with the vehicle raised.
The jack is designed only to raise and hold the
R
vehicle for a short time while a wheel is being
changed. It must not be used for performing
maintenance work under the vehicle.
Avoid changing the wheel on uphill and down-
R
hill slopes.
Before raising the vehicle, secure it from roll-
R
ing away by applying the parking brake and
inserting wheel chocks. Do not disengage the
parking brake while the vehicle is raised.
The jack must be placed on a firm, flat and
R
non-slip surface. On a loose surface, a large,
flat, load-bearing underlay must be used. On a
slippery surface, a non-slip underlay must be
used, e.g. rubber mats.
Do not use wooden blocks or similar objects
R
as a jack underlay. Otherwise, the jack will not
be able to achieve its load-bearing capacity
due to the restricted height.
Make sure that the distance between the
R
underside of the tires and the ground does not
exceed 1.2 in (3 cm).
Do not place your hands or feet under the
R
raised vehicle.
Do not lie under the vehicle.
R
Do not start the engine when the vehicle is
R
raised.
Do not open or close a door or the trunk lid
R
when the vehicle is raised.
Make sure that no persons are present in the
R
vehicle when the vehicle is raised.
Vehicles with alloy wheels and hub caps: the
wheel bolts are covered by a hub cap. Before you
can unscrew the wheel bolts, you must remove
the hub cap. Two different variants can be instal-
led.
Changing a wheel
Vehicles with plastic hub cap:
To remove: turn the center cover of hub
X
cap : counter-clockwise and remove.
To install: before installing, ensure that hub
X
cap : is in the open position. To do this, turn
the center cover counter-clockwise.
Position hub cap : and turn the center cover
X
clockwise until hub cap : engages physically
and audibly.
Make sure that hub cap : is installed
X
securely.
Vehicles with aluminum hub cap:
To remove: take socket ; and wheel wrench
X
= from the vehicle tool kit (
Position socket ; on hub cap :.
X
Position lug wrench = on socket ;.
X
Using lug wrench =, turn hub cap : coun-
X
ter-clockwise and remove it.
To install: before installing, check hub cap :
X
and the wheel area for soiling and clean if
necessary.
Put hub cap : in position and turn until it is in
X
the right position.
Position socket ; on hub cap :.
X
Attach lug wrench = to socket ; and
X
tighten hub cap :.
329
page 292).
Y
Z
Hide quick links:
Advertisement
Table of Contents
