Samsung VP-L100 Service Manual page 59

Alignment and adjustment
5-3-3 VCR Section
From now on, the structure of every adjustment is as follows.
Note 1 : How to connect the A/V cable to the camcorder and the pattern generator.
-. Connect the A/V cable to the camcorder and the pattern generator as shown below.(Fig 2)
-. The yellow one is video.
Note 2 : How to record in the VCR mode -. Press the DSE button on the FUNCTION-VCR board in the VCR
adjustment mode.
Note 3 : -. Refer to the page 5-41 for the check point of the video block adjustment.
-. Refer to the page 5-42 for the check point of the audio block adjustment.
Note 4 : What is the OSD in the VCR adjustment.
0 Ñ It means the mode number of under adjustment.
EMPHA - It means the mode name of under adjustment.
EPR:XX - It means the value which exist in the camcorder already.
EVR:XX - It means the value which changing value of under adjustment.
It is changed by the data-up button and the data-down button.
If you satify to a value of under adjustment, press the confirmation button for writing
in the camcorder, then the value of the EPR:XX is updated to the value of EVR:XX.
Note 5 : The adjustment mode number means below.
-.0ÑY.Emphasis adjustment.
-.2ÑY.FM.Carrier adjustment.
-.4ÑRecord Y level adjustment.
-.6ÑAudio Deviation adjustment.
-.8ÑVolume center value setting.
-.AÑCustom code setting.
-.BÑModel Number setting.
5-38
Fig. 2 Video Signal Connection
-.1ÑY.separation adjustment.
-.3ÑY.FM.deviation adjustment.
-.5ÑPB out level adjustment.
-.7ÑAudio BPF adjustment.
-.9ÑHead Switching Point adjustment.
0. EMPHA
EPR:XX EVR:XX
Samsung Electronics