Samsung VP-L100 Service Manual page 24

The function buttons on the Menu Board are used to control the camcorder additionally,
These buttons should be used for adjustment of the camera section.
Menu Board for camcorder adjustment
Note : In service adjustment mode, button names are different from those in customer camera function control
mode. EX) TITLE button is the same as confirm.
5. How to get into service ÒADJUSTÓ mode
STEP 1
1. Connect the power source (battery/
DC cable).
2. Eject the tape if it is in the unit.
3. Set the power switch of the
camcorder to ÒCAMERAÓ position.
4. Set OSD on state.
Note : When ÒXX XXÓ is shown in service adjustment precedures, this indicates variable values.
Samsung Electronics
Figure of button placement when Menu Board is
Reassignment
in the
adjustment mode
STEP 2
1. PRESS ÒDSEÓ Button 3 times on the camcorder.
2. It goes to into ÒNEGAÓ mode.
3. Press and hold the ÒEJECTÓ button and
ÒDISPLAYÓ button on the camcorder at the same
time for more than 3 seconds. Then unit goes into
service mode.
STEP 3
On screen display show "CD HALLA XX XX"
CAMERA ADJUSTMENT mode has successfully
been activated.
Alignment and adjustment
used for service adjustment.
OSD
NEGA
5-3