When Booting Up The Computer; When Shutting Down The Computer; Windows Boots Up In Safe Mode; The Computer Is Not Shut Down - Samsung R60 NP-R60FY series Service Manual

- This Document can not be used without Samsung's authorization -
4. Troubleshooting

◆ When booting up the computer

18. The "Invalid System Disk. Replace the Disk and then press any key" message appears.
→ This message may appear when the connected USB memory or CD media does not include
bootable data.
→ The "Reboot and Select the proper Boot device or Insert a bootable media in the selected Boot
device and press a key" message appears.
→ Check if the signal and power cables are properly connected to the hard disk drive.
→ Check if the hard disk drive is recognized in the BIOS SETUP.
→ The operating system on the hard disk drive is corrupted. Reinstall Windows.
19. The "To enter BIOS SETUP, press <F2>. To continue, press <F1>." message appears.
→ This may happen when the BIOS settings are different from the system environment. In this
case, setup the BIOS according to your system environment.
→ Press <F2> to enter the BIOS SETUP.
→ Check if the date and time are correct in the BIOS SETUP.
→ Save the settings and restart the system.
20. The 'CMOS Checksum error' message appears.
→ This message may appear when the CMOS battery of the main board is completely discharged.
In this case, replace the battery with a new one of the same type and set up the BIOS SETUP
according to your system environment.

21. Windows boots up in safe mode.

→ This may happen when Windows was not shut down normally. Therefore, shut down the system
by selecting Start > Turn Off Computer.
→ This may happen when the system settings have been incompletely recognized.
→ Run Check Disk.
22. I cannot boot up the computer with a USB floppy drive or from USB memory.
→ Check if the diskette is bootable.
→ This may happen when the booting priority of the device is low. In this case, change the
booting priority in the BIOS SETUP.

◆ When shutting down the computer

23. The computer is not shut down

→ If Windows does not end normally, you can forcibly shut down the system by pressing the
Power button. If the power-saving feature is activated on the Power button, press the Power
button for more than 4 seconds to turn the computer off. If the computer is then turned on again,
Check Disk is automatically run.
5-19