Dial Standby/Return To Dial - Paradyne COMSPHERE 3800PLUS User Manual

Select Disconnect.
Disconnect
Command Complete
F1 F2
The modem goes on-hook (hangs up) and the call is
disconnected. This includes any calls being used for dial
backup of leased lines. The Command Complete status
message is displayed.
To exit this function and remain in the Call Setup
branch, press the key. To exit and return to the
Top-Level menu, press the
AT Command Equivalent
The AT command equivalent for Disconnect is H or
H0.
Answer
Answer allows the modem to go off-hook, generate an
answer tone, and begin the handshaking process with the
calling modem. Use the Answer function when the
Auto-Answer Ring Count configuration option is
disabled. (See the Line Dialer
Configure Branch.)
To access Answer from the Call Setup branch, make
the following selections:
Call Setup:
Answer
F1 F2
3980-A2-GB30-40
F3
key.
section in Chapter 8,
F3
DIAL BACKUP LINE
DIAL
STANDBY
MODEM
Figure 5-1. Dial Backup
Press the key until Answer is displayed. Select
Answer.
Answer
Command Complete
The modem goes off-hook and attempts to establish a
connection in Answer mode. The Command Complete
status message appears on the LCD.
To exit this function and remain in the Call Setup
branch, press the
Top-Level menu, press the
AT Command Equivalent
The AT command equivalent for Answer is A.

Dial Standby/Return to Dial

The Dial Standby and Return to Dial functions appear
on the LCD only after the modem, operating on leased
lines, is placed into dial backup. Once the modem is
operating in Dial Backup mode, these functions allow the
modem to be switched back and forth between dial and
leased-line operation while still maintaining the dial
connection. See Figure 5-1. (Switching between dial and
leased-line operation can be performed manually or
automatically by enabling the Auto Dial Standby
configuration option.)
RETURN
TO DIAL
X X
LEASED-LINE
FAILURE
October 1998
Call Setup Branch
F1 F2 F3
key. To exit and return to the
key.
MODEM
496-13081-01
5-3