Important Safety Instructions; Power Supply Installation; Telecommunication Installation; Coax Installation - Motorola nvg589 Administrator's Hanbook

Vdsl2
Hide thumbs Also See for nvg589:
Table of Contents

Advertisement

Administrator's Handbook

Important Safety Instructions

POWER SUPPLY INSTALLATION

Connect the power supply cord to the power jack on the Motorola
priate electrical outlet. There is no power (on / off) switch to power off the device.
WARNING:
The power supply must be connected to a mains outlet with a protective earth connection.
Do not defeat the protective earth connection.
CAUTION:
Depending on the power supply provided with the product, either the direct plug-in power supply
blades, power supply cord plug or the appliance coupler serves as the mains power disconnect. It is
important that the direct plug-in power supply, socket-outlet or appliance coupler be located so it is
readily accessible.

TELECOMMUNICATION INSTALLATION

When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of
fire, electric shock and injury to persons, including the following:
Do not use this product near water, for example, near a bathtub, wash bowl, kitchen sink or laundry tub, in a
wet basement or near a swimming pool.
Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of
electrical shock from lightning.
Do not use the telephone to report a gas leak in the vicinity of the leak.
CAUTION: The external phone should be UL Listed and the connections should be made in accordance with
Article 800 of the NEC.

COAX INSTALLATION

Be sure that the outside cable system is grounded, so as to provide some protection against voltage surges and
built-up static charges. Article 820-20 of the NEC (Section 54, Part I of the Canadian Electrical Code) provides
guidelines for proper grounding and, in particular, specifies the CATV cable ground shall be connected to the
grounding system of the building, as close to the point of cable entry as practical.

PRODUCT VENTILATION

®
The Motorola
Gateway is intended for use in a consumer's home. Ambient temperatures around this product
should not exceed 104°F (40°C). It should not be used in locations exposed to outside heat radiation or trapping
of its own heat. The product should have at least one inch of clearance on all sides except the bottom when prop-
erly installed and should not be placed inside tightly enclosed spaces unless proper ventilation is provided.
CAUTION
The battery used in this device may present a risk of fire or chemical burn if mis-
treated. Do not disassemble, heat above manufacturer's maximum temperature
limit, or incinerate. Replace battery with Motorola P/N 586185-001-00 only. Use of
another battery may present a risk of fire or explosion.
Dispose of used battery promptly. Keep away from children. Do not disassemble
and do not dispose of in fire.
SAVE THESE INSTRUCTIONS
12
®
Gateway. Plug the power supply into an appro-

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents