Charging System Monitor - Actron CP9680 User Manual

en | 4 0 | User guide | CP9680 AutoScanner® Plus
battery) or a battery with a different capacity (mAh), the
vehicle may require reprogramming to the new battery
type in addition to performing the battery reset. Repro-
gramming is not a function of the tool. Consult the
vehicle manual for additional vehicle-specific informa-
tion.
From the Special Tests Menu:
1. Select Battery Reset.
• Use the UP and
Reset is highlighted.
• Press .
Special Tests
I/M Monitors
Drive Cycle Monitor
State OBD Check
MIL Status
O2 Monitor Tests
Diagnostic Monitor Tests
On-Board Systems
Vehicle Information
Battery Reset
2. Follow the instructions displayed. They will vary
depending on the vehicle.
• Press .
Battery Reset
Required Whenever:
Battery has been replaced
Otherwise instructed by shop
manual
Press ENTER to continue
3. Perform Battery Reset.
• The messages displayed during battery reset
will vary depending on the vehicle.
Battery Reset
(May Take 30 Secs)
Time remaining
Please Wait
4. Battery Reset Complete.
• Press to return to the Special Tests Menu.
573102 | REV. A | 07.2015
DOWN keys until Battery
0:28
Battery Reset
Battery System Reset Complete
Press ENTER to continue
5.16

Charging System Monitor

The Charging System Monitor function allows the Scan
Tool to provide voltage measurements at the DLC to give
an indication of battery, starter, and alternator perfor-
mance.
From the Special Tests Menu:
1. Select Charging System Monitor .
• Use the UP and
System Monitor is highlighted.
• Press .
Special Tests
Drive Cycle Monitor
State OBD Check
MIL Status
O2 Monitor Tests
Diagnostic Monitor Tests
On-Board Systems
Vehicle Information
Oil Light Reset
Charging System Monitor
2. Turn the ignition key on but do not start the engine.
• Press .
Charging System Monitor
Turn the key on.
Do NOT start the engine.
Press ENTER to continue
3. The DLC voltage is measured at key on engine off.
• The screen below shows a KOEO voltage of
12.2V.
• Start the engine or press
Diagnostic Menu. The Scan Tool will monitor the
DLC voltage and progress to step 4 if starter
cranking is detected.
DOWN keys until Charging
to return to the
Bosch Automotive Service Solutions Inc.