Mil Status; State Obd Check - Actron CP9680 User Manual

Select Module
OBDII/EOBD
Engine
ABS
Airbag
4. Observe "Command sent" message is displayed.
• Press .
Erase Codes
Command sent
Codes remaining:0
Press ENTER to continue
5. Return to Diagnostic Codes Menu.
• Press .
5.4

MIL Status

From Special Tests Menu:
1. Select MIL Status.
• Use the UP and
Status is highlighted.
• Press .
Special Tests
I/M Monitors
Drive Cycle Monitor

State OBD Check

MIL Status
O2 Monitor Tests
Diagnostic Monitor Tests
On-Board Systems
Vehicle Information
Oil Light Reset
2. View MIL Status.
• Press to return to Special Tests Menu.
MIL is ON
MIL lamp should be ON if
engine is running
Press ENTER to continue
Bosch Automotive Service Solutions Inc.
DOWN keys until MIL
CP9680 AutoScanner® Plus | User guide | 29 | en
MIL is OFF
MIL lamp should be OFF
engine is running
Press ENTER to continue
5.5 State OBD Check
The State OBD Check function is used to display a basic
status of the vehicles OBD system.
• Malfunction indicator lamp (MIL) status
• Codes found
• I/M monitors
Erase Codes deletes DTCs and resets I/M monitors from
vehicle's computer module(s).
The State OBD Check function has the following areas:
• MIL Status ON or OFF
• Number of Codes Found
• Number of Monitors OK
• Number of Monitors Inc
• Number of Monitors N/A
State OBD Check should be done with the key on
engine running (KOER) due to showing MIL status.
The number of codes found are only Global OBD II codes and
not pending codes.
The number of monitors that are either ok, inc, or na are
only Since DTCs Cleared and not This Drive Cycle.
Refer to Read Codes and I/M Monitors for more
detailed information about the results.
From Special Tests Menu:
1. Select State OBD Check.
• Use the UP and
OBD Check is highlighted.
• Press .
Special Tests
I/M Monitors
Drive Cycle Monitor
State OBD Check
MIL Status
O2 Monitor Tests
Diagnostic Monitor Tests
On-Board Systems
Vehicle Information
Oil Light Reset
2. View State OBD Check display.
DOWN keys until State
573102 | REV. A | 07.2015