Teledyne LeCroy
Report between Cursors
Click the option button next to the From cursor selection drop down list. Then click the
From down arrow and choose the 1st cursor, click the To down arrow to choose the 2nd
cursor, and click OK. The resulting report has only the capture between the cursors.
Figure 3.37: Report between Cursors
Report between Events
Click the option button next to the From the event selection dropdown list, click the
From down arrow to choose the 1st event, then enter the number of its occurrence. Next
click the To down arrow to choose the 2nd event, then enter the number of its
occurrence.
Figure 3.38: SATA: Report between Events
Click OK. The resulting report are limited to the capture between the defined events.
SAS vs. SATA: SAS adds Transport, SCSI Cmd, SMP Cmd, and Task Mng to the drop‐down
list and deletes FIS and Phy Reset.
Performance Reference Definitions
Trp. No. ‐ Number of Transports
Resp. Time ‐ Response Time
Pld. Bytes ‐ Payload Bytes
Latency Time
246
The total number of transports that compose this exchange.
The time taken to transmit this command on the link(s) from the beginning of the
first frame in the command to the end of the last frame in the command.
The number of payload bytes this operation transferred.
The time measured from the transmission of the command to the first data
transmitted for this IO operation.
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Analysis