Rinnai infinity 32 HD 250 E User Manual page 24

OPERATION WITH DELUXE BATHFILL TEMPERATURE
Step 2 – Activate the automatic Shower saver / Bath fill function and follow the voice prompts.
(a) Ensure the system is switched on. When the system is ON, the monitors will be lit. Ensure
the 'Transfer' button is lit. If not, press the 'Transfer' button once.
(b) Press 'Shower Saver / Bath fill' button. The
'Shower Saver / Bath fill' button will light up and
the buzzer will sound. The 'Bath' indicator on the
Kitchen Controller monitor will light up. The voice
will say "The hot water system is ready. Open the
hot water tap."
(c) Open the hot water tap for the shower or bath. The
combustion indicator on all Temperature
Controller(s) will light up and the shower will run
or the bath will start to fill.
CHECK WATER TEMPERATURE BEFOR USE.
A parent should always check the temperature before a Child is placed in contact with hot water.
CAUTION
During Shower Saver / Bath fill, the time display on the Bathroom Controller will show the
remaining shower / bath fill volume and will 'count down' the volume remaining.
NOTE
If you wish to stop the water flow whilst the shower saver / bath fill function is in
operation, simply press the 'Shower Saver / Bath fill' button. The 'Shower Saver / Bath
fill' button
If you wish to stop the water flow whilst the shower saver / bath fill function is in
operation, simply press the 'Shower Saver / Bath fill button'. The 'Shower Saver / Bath
fill' button will flash and the voice will say "Turn off all hot water taps and press the 'Bath
fill' button". Follow these instructions.
(d) When the shower / bath fill is finished to the programmed volume & temperature (see 'Step 1'):
the flow from the shower / bath hot water tap will stop;
•
the 'Shower Saver / Bath fill' button on the Bathroom Controller(s) and the 'Bath'
•
indicator on the Kitchen Controller monitor will flash;
the buzzer will sound;
•
the voice will say "Bath fill is complete. Turn off the bath hot water tap and push the
•
'Bath' button."
(e) IMPORTANT – When filling a bath, close the hot water tap for the bath when the bath is
full. This is very important to prevent over filling of the bath.
(f) Press the 'Shower Saver / Bath fill' button. This is also important. It tells the hot water unit that
the customer is aware that the shower or bath fill function has been completed and that the hot
water tap for the shower or bath has been shut. The hot water unit will not allow hot water to
flow from any fixture until the 'Shower / Bath fill' button has been pressed.
The 'Shower Saver / Bath fill' button light on the Bathroom Controller and the 'Bath' indicator
on the Kitchen Controller monitor will go out.
NEVER LEAVE YOUNG CHILDREN UNATTENDED IN THE BATH.
When using the 'Shower saver / Bath fill' function, ALWAYS close the hot water tap for the bath
after the bath has filled and flow has stopped.
CAUTION
CONTROLLERS
- 23 -