Rinnai infinity 32 HD 250 E User Manual page 23

OPERATION WITH DELUXE BATHFILL TEMPERATURE
(a) Ensure the system is switched 'ON'. When the system is ON,
the monitors will be lit. Ensure the 'Transfer' button is lit.
If not, press the 'Transfer' button once.
(b) Select the desired temperature using the 'Shower / Bath temp.'
buttons located behind the flip panel. The selected temperature
will be displayed on the bottom of the bathroom controller
monitor and will remain until it is next changed.
(c) Select the desired shower / bath volume using the 'Water Vol.'
Buttons located behind the flip panel. The selected volume will
be displayed at the bottom of the bathroom controller monitor
numerically, and graphically by the long bar against the level
markers. During the first bath fill, it is recommended that the
lowest bath fill volume is used. During subsequent bath fills this
can be increased depending on the volume of your bath and the
desired level.
The relationship between shower / bath volume in litres and the position of the long bar against
the level markers is as follows.
Eg. 120 litres – denoted numerically and by the second level marker from the bottom of the
monitor, as shown below.
Volume (L)
Position of
long bar
12
400
12
350
300 11
280 10
260
240
220
200
180
160
140
120
100
60
30
(d) After approx. 5 seconds, the numeric volume
displayed will revert to the shower saver / bath
fill temperature previously set. The long bar on
the level markers will remain.
CONTROLLERS
9
8
7
6
5
4
3
2
1
30 & 60 litre option
1
not available on the
1 infinity 24
- 22 -
Remember that the bath
level markers on the
display are not a true
representation of your bath.
ie. the 'half-way' mark on
the monitor is not
necessarily the 'half-way'
mark on your bath.
The average bath size
is 160 litres.
Be careful not to
overfill the bath!
NOTE