Panduit Cougar LS9 Operator's Manual page 35

LABELING EXERCISES
Enter start, end, and increment values
Scroll down or up to Place On...
Select Place On... Labels (this allows more than 9
terminals in a serialization
•
Step 6: Press Print
If you see the Tools too big error, then reduce the font size,
o
increase terminal space, or check the label rotation.
Hint: You can separate the terminal legends with
lines across the label. To do this, press the
Line key, select @ Pages – Yes. Press Enter.
You can change the terminal spacing by:
• Pressing the Shift + DEL keys, to
Clear All Pages & Format. Then enter
a new terminal space and press the Enter
key.
•
...Or by using the LENGTH function.
Exercise 7
Create DIN terminal block labels
NOTE: DIN terminal block labeling is based on European standards and
is primarily used in European countries. The unit of measure for
length in DIN Mode is millimeters (mm).
•
Step 1: Insert a continuous tape cassette, such as T050X000VPC-BK
•
Step 2: When prompted, select New Blank File. Save previous label if
necessary.
•
Step 3: Press F5 to begin the DIN Mode function.
•
Step 4: Enter the Module Size
•
Step 5: Enter the Module Span
•
Step 6: Create label text or tools
•
Step 7: Press Print
•
Step 8: Repeat steps 4 through 6 until print job is complete
•
Step 9: Press DEL at steps 4 or 5 to exit DIN Mode
35